Heaved slabs, through-cracking, and subbase failures replaced to the correct slope, finish, and dimension — ready for coating if the design calls for it.
Heaved, cracked through, or failed past coating viability. New concrete installed correctly gives The Armor Core System™ the foundation it was designed to bond to.
Heaved, cracked, and trip-hazard sections replaced to match the grade, width, and finish of the surrounding concrete. The work should look like it was designed to be there.
Through-cracking, settlement, and severe deterioration removed and replaced. Finished and graded for outdoor living, coating application, or Rubaroc® surfacing.
Water exposure, chemical contact, freeze-thaw cycling, and constant foot traffic take their toll. When the slab is beyond restoration, replacement is the right foundation for Rubaroc® or The Armor Core System™.
Loading dock approaches, parking areas, entrance slabs, and commercial walkways replaced to the specification the application demands — not the minimum that gets the job done cheapest.
Spalled, cracked, and crumbling entry steps and stoops replaced cleanly. Finished to match the surrounding concrete or prepped for a Rubaroc® or coating application on the same visit.
Not sure which category your concrete falls into? The free assessment is designed to answer exactly that — no cost, no obligation.
Get a Free AssessmentEvery step matters. None are optional.
We evaluate structural condition, cracking pattern, subbase integrity, and drainage. If replacement is the right answer, we say so. If it isn't, we say that too — and recommend what is.
Clean, professional removal of the existing slab. We haul everything off-site. The subbase is then evaluated, compacted, and graded before any new concrete goes down. This is where most replacements cut corners. We don't.
Forms set to the correct grade, slope, and dimension. Proper drainage slope is engineered into every project — not assumed. Control joints are planned and placed to manage where the concrete will crack as it cures, rather than leaving that to chance.
Concrete placed, struck off, and finished to the specified surface texture — broom finish, exposed aggregate, smooth, or finished for a subsequent coating or Rubaroc® application. If a coating follows, the surface profile is optimized for it from the start.
Proper curing separates concrete that lasts from concrete that deteriorates prematurely. We control the curing environment and timeline to ensure the slab reaches full design strength — and coordinate the coating schedule if the project includes one.
Once the new slab has cured, we can apply The Armor Core System™ polyurea coating or Rubaroc® rubber surfacing on the same project. New concrete plus a lifetime-warranted coating finish — coordinated start to finish by one company.
Not every damaged slab needs to be torn out. And not every damaged slab should be coated. Some concrete has reached the end of its useful life — structurally compromised, heaved beyond leveling, or deteriorated past the point where any surface treatment will hold. When that's the case, the right answer isn't a coating. It's replacement.
Most contractors have one answer for every problem — whatever they sell. A coating contractor recommends a coating. A concrete contractor recommends a pour. Outback is one of the few companies that can honestly evaluate your concrete and recommend the solution that makes sense — coat it, resurface it, or replace it — because we do all three.
"That position requires sometimes telling a homeowner that the coating they came in wanting isn't the right answer — and recommending a full replacement when a coating would be cheaper to sell. We put the right outcome for the surface ahead of the easier sale."
We install polyurea coatings, Rubaroc® rubber surfacing, and pour new concrete. That range means we have no incentive to recommend the wrong solution.
Every project starts with an evaluation of the actual concrete — structural condition, cracking, subbase, and drainage. The recommendation follows the findings, not the margin.
You get an exact price before any work begins. No estimates that grow after we've started. No pressure to approve work on the spot. Free assessment, no obligation.
